Haislip
Farms
Racing

Info

 Super Stock  

4 Flat Hole Classes – DOT Tires Only

Class A 33 – Class B 36 – Class C 38 –Class D 44

 1 Hill & Hole Class (any DOT tire size) - Must Have Roll Cage

  • Must have full body and frame minimum trimming of corners of fenders for clearance is allowed
  • No Coil Overs
  • No 3 or 4 link
  • Harmonic balancer must in front of the front axle
  • Not to exceed 150” wheel base
  • No full hydro steering
  • No fuel injection unless factory equipped
  • Any single gas carburetor allowed-no alcohol
  • No sheet metal intakes
  • No spacer plates between intake and head
  • Must have leaf springs – minimum 3
  • Must retain factory firewall and floor board
  • No blowers
  • No aluminum blocks
  • Driver must be seated in factory location

MODIFIED

1 Flat Hole Class – DOT Tires Only

 1 Hill & Hole Class (any DOT tire size)



  • Motor from front of rear to the front of the harmonic balancer – no more than 12”
  • Not to exceed 150” wheel base
  • No coil overs
  • No 3 or 4 link
  • Must have front & rear drive shaft yoke loops
  • Must have OEM frame or a constructed frame of 2x3 steel
  • Must have fire wall between driver and motor
  • Must have leaf springs or IFS or coil and radius arm
  • No blowers
  • No aluminum blocks
  • Alcohol is permitted
  • Driver seated in center of cab allowed – must be seated behind engine

SUPER MODIFIED

1 Hill & Hole Class (any DOT tire size)

  • 3 or 4 link allowed
  • Coil Overs allowed
  • Not to exceed 150” Wheel Base
  • Must have front & rear drive shaft yoke loops
  • Alcohol allowed – must have approved fire suit
  • Must have Electrical Disconnect
  • No Rear Engine

UNLIMITED Hill & Hole

  • Minimum 8 point roll cage required – fully gusseted
  • Nitrous/Alcohol allowed – must have approved fire suit
  • Must Have Electrical Disconnect

Deer Hunter Class (includes 4&6 cyc.)

Flat Hole - 36” tire & under (DOT tires only)

  • Single gas carburetors - No dominators 
  • No fuel injection unless factory equipped
  • Engine must be located in stock position
  • Must have factory harmonic balancer
  • No aluminum blocks or heads
  • Big Blocks allowed – must have factory intake
  • No V8’s in mini trucks or SUV’s (unless OEM)
  • Headers are allowed
  • Must be full factory frame &  body
  • Engine & Vehicle must be same manufacturer
  • No 3 or 4 link or coil overs
  • No full hydro steering
  • No sheet metal intakes
  • OEM style suspension only
  • Stock steel body (minimal cutting allowed for tire clearance)
  • Fuel tank, battery and radiator must be in stock location
  • Must retain factory firewall and floor board
  • Driver must be seated in factory location

 

 

 

 

 

Website Builder